How to Fix a Dead Kia Picanto Key Fob
The Kia Picanto was built for the city. It swerves through traffic voids that larger vehicles can't, and navigates width limits as if they're not even there. It's a small car packed with features.
There are many reasons your Kia Picanto key fob may not be functioning. A dead battery is the most common cause.
Dead Coin Battery
The most frequent reason why a Kia Picanto key fob stops working is a dead or dying battery. The key fob will usually display warning signs such as unpredictable behavior or loss of range before it dies. If you see these indications, it is recommended to replace the battery before it fails completely. Make sure you choose the same replacement battery with identical in size, voltage, and specification as your original one.
If the key fob still not working, you might be required to take it to a dealer. Only then can you be certain that the replacement key fob will be compatible with your vehicle and will be programmed correctly. If you attempt to reprogram your key fob in the absence of proper procedure can damage the internal chip and result in it not functioning.
Another possibility is that the receiver module has developed a fault. This could be due to an unintentional chip damage or wear and tear over time. The signs of this issue may be difficult to detect however it is crucial to find out the cause as soon as possible. If you're not able to get your key fob to lock or unlock your doors, or even if the spare isn't working then you should call a dealership or a service center to get help. They'll be able identify the issue and fix it for you.
Faulty Chip
The key fob contains a chip that transmits the signal to a computer within the car. If the chip is damaged it will not send the correct code, and the immobilizer system of the car will be activated. This could be due to several reasons. One reason could be an insufficient battery in the key fob. Another possibility is water damage. It is likely that the fob will not function if it gets wet.
A damaged chip could be the reason a Picanto fob doesn't turn on the engine. If you've replaced the battery and tried reprogramming the fob but it does not work, it could be that the circuit board is damaged. If this is the case, you will have to replace the circuit board.
To open the Fob you will need to press on the button on the side of the fob. After this, you can remove the mechanical key. Then, follow the video below to replace the key fob's battery. Make sure you use an alternative battery that has the same voltage and size. The Fob might be damaged if you use the wrong type battery. Press the lock button after replacing the battery. If it works, you have a working Fob.
Faulty Receiver Module
Your key fob is subject to quite a beating and isn't completely indestructible. Over time, its batteries' contacts and buttons could become damaged and stop working properly. It's simple to fix the problem using a few tools.
To work, the fob has to transmit a signal to a receiver inside your car. If the module is defective the fob won't be in a position to open or start the car. There are a myriad of possibilities for the cause of this issue, but the first thing to do is reset the fob.
This is usually done by disconnecting the 12 volt battery from the fob and allowing it to drain completely. Then, reconnect replace kia car key The Keylab and positive cables in reverse order.
If the battery is in good shape and the fob does not have any water damage, the problem might be with the signal. This can be due to a number of factors, including interference from nearby transmitters and objects that operate on the same frequency band as the Receiver of Picanto.
Key fobs come with rubber seals in order to protect the chip from getting wet. However, if they're submerged in water for prolonged periods the chips may be destroyed. It is essential to keep your key fob clear of water and only use key fobs with waterproof designs.
Programming errors
A Kia Picanto key fob is a convenient way to unlock and start your car. You can also use the key fob in order to control your vehicle. It is important to know how to use your key fob, especially if you are driving in bad conditions or have a limited mobility. There are many Kia Picanto keys tricks that can help you.
If your key fob stopped functioning out of the blue it could be due to an issue with its internal chip. It is not a common occurrence however it could happen. To determine the cause you should talk to an Kia dealer.
Alternatively, you can try to reset your Picanto key fob. The procedure is easy and can be accomplished at home. The first step is to remove the key fob. Then, connect the diagnostic tool to the OBDII port that is located beneath the dash. Then, turn on the engine. The diagnostic tool will then ask you for details about the Picanto. This includes the make model, year, and VIN.
You can also examine the battery for dead coin battery. The metal retaining clips inside the key fob are designed to hold the battery in place and complete the circuit. If the retaining clips are loose it could disrupt the flow of electricity causing an interruption in function.